Wind Load Test Report for Electric PoleSuitable for mechanical performance testing of circular reinforced concrete poles. Including technical requirements for experimental instruments and equipment, as well as evaluation of experimental results.

1 Scope of application
1.1 Cantilever test method
Suitable for mechanical performance testing of conical rods with different tip diameters.
1.2 Simple supported test method
Suitable for mechanical performance testing of equal diameter rods with different diameters.
2 test pieces
The test piece shall be randomly sampled according to the regulations of factory inspection or type inspection.
3 Experimental instruments and equipment
3.1 Pedestal
The support seat used to fix the specimen can be made of steel or reinforced concrete. During cantilever testing, in order to eliminate
The self weight of the pole section affects the use of flexible rolling supports.
3.2 Loading equipment
Electric mechanical transmission, winch or manual hoist can be used to apply loads.
3.3 Instruments
The measuring instruments used in experiments should be calibrated according to the prescribed time limit.

Technical parameters:

Load sensor: 0-20KN, accuracy 0.01KN;

0-200KN, accuracy 0.1KN;

Disturbance meter: 0-1800mm, division value 1mm;

0-50mm, division value 0.1mm;

Configuration List:

1. A set of 20KN tension sensor and lifting ring;

2. A set of 200KN tension sensor and lifting ring;

3. A set of 1800mm disturbance sensor and bracket;

4. Two sets of 50mm displacement deformation sensors and brackets;

5. Four signal wires (tension, disturbance, deformation);

6. One power cord and one battery box each;

7. One copy of the instruction manual and certificate of conformity;

8. One packaging box;

Wind Load Test Report for Electric PoleSuitable for mechanical performance testing of circular reinforced concrete poles. Including technical requirements for experimental instruments and equipment, as well as evaluation of experimental results. The product meets the testing requirements for load, deflection, and displacement of cement rods in GB/T4623-2014 "Mechanical Test Methods for Circular Cement Products". It also meets the one paper certification review requirements of State Grid and Southern Power Grid.