SGEP-300C Continuous Monitoring System for Smoke Emissions-Fornitore globale

Building 15, Aobei Science and Technology Park, No.1 Baosheng South Road, Haidian District, Beijing, China

Product Introduction:

The SGEP-300C continuous monitoring system for flue gas emissions is a flue gas online monitoring system developed by our company to meet the requirements of relevant national atmospheric emission standards, absorb advanced and mature international technologies, and combine with the actual situation on site in China (low temperature, high humidity, high corrosion). The system is based on the EL3020 gas analyzer from ABB in Germany, and is designed and developed using automation control technology, computer application technology, and related specialized analysis software. It is a complete system from sampling, preprocessing, gas analysis to data acquisition and upload.

Mainly used for treating SO in flue gas₂、 Dynamic continuous monitoring of pollutants such as NOx, as well as monitoring of other parameters such as oxygen, temperature, pressure, flow rate, humidity, etc. Through a data acquisition and processing system, charts are generated and the monitoring data is transmitted remotely to environmental protection departments at all levels in accordance with the HJ212 national standard communication protocol, thereby achieving remote continuous monitoring of the flue gas emission process.

Detection principle:

Product features:

1. All parts in contact with smoke are made of heat-resistant and corrosion-resistant special stainless steel, polytetrafluoroethylene and other materials;

2. Adopting heated direct sampling and high-temperature heat tracing transmission to avoid condensation of flue gas, the measurement is more representative;

3. Special preprocessing system.

Efficient dehydration condenser, outlet Td ≤ 5 ℃, in compliance with HJ76 standard;
SO₂Loss of quantitative measurement;
Acid compensation SO₂lose.

4. Real time dew point value display and dew point over limit alarm.

Prevent smoke condensation and dissolve SO₂、 NO₂Gas corrosion instruments;
Avoiding analysis bias and corrosion of the analysis system caused by water condensation.

5. Equipped with automatic zero calibration function.

6. Dual range automatic switching function.

7. Multi channel analog input/output function.

8. Easy to operate, fast to set up, easy to run, low maintenance workload, and low cost.

Technical parameters:

Application areas:

Used for the emission of SO in flue gas from pollution sources such as thermal power, steel metallurgy, cement, chemical, industrial boilers, industrial kilns, and waste incinerators₂、 Dynamic continuous monitoring of NOx, as well as control monitoring of flue gas desulfurization and denitrification systems.