·Provide isolated power voltage to two-wire or three wire transmitters on site, and isolate and convert the 4-20mA signal generated by the transmitter before outputting it to the control system or other instruments.

·The isolation distributor adopts an independent DC power supply method and supports output circuit power supply, with isolation between the power supply input output.

·Standard 35mm DIN rail card installation. Pull out plug terminals with spring compression connection.

● Input

Input signal: 4~20mA

Input impedance: 24 Ω

Power distribution for transmitter: ≥ 18V (factory default) at 20mA. If larger power distribution is required (e.g. ≥ 22V), please specify when ordering

Maximum input current: approximately 24mA

● Output

Output current (lo): 4~20mA

Output circuit supply voltage (Ue): 12~35V

Voltage drop (Ud): 3V

Output load resistance (RL): Calculation formula RL ≤ (Ue Ud) ÷ 0.02

Output ripple:<10mVp-p

(Note: The selection of power supply voltage for the output circuit should be determined based on the size of the load. If the voltage is too high and the load is very small, it will aggravate the heating condition of the isolator.)

● Power supply

Supply voltage range: 20-30VDC

Rated supply voltage: 24VDC

Current consumption (when powered by 24VDC):

<38mA (1 in 1 out); <57mA (1 in 2 out); <90mA (2 in 2 out)

● Comprehensive parameters

Standard accuracy: ± 0.1%

Temperature drift: ± 0.015%/℃

Response time:<10ms

Isolation capability: 2.5KV, 1min, 50Hz between input output power supply

Insulation resistance: ≥ 100MQ/500VDC between input output power supply

Working environment temperature: -20~+60 ℃

Storage environment temperature: -40-+80 ℃

Shell material/protection level: PC (polycarbonate) material/IP20

Dimensions: 16 × 116 × 110 (mm)