After upgrading, the FT-106 ordinary abrasive bulk density tester has added the following functions: configuring the positioning angle, adjusting the level device, and reducing the influence of external environment on the measurement results; The funnel and measuring cup have positioning devices to ensure that the center of the funnel and container are in a straight line.Detailed informationFT-106Ordinary abrasiveBulk density tester

,Abrasive materialsBulk density meterFT-106Ordinary abrasiveBulk density tester

(Original)DMP-II）FT-106Ordinary abrasive

Bulk density testerAfter the upgrade, the following features have been added:Configure the positioning angle, adjust the level device, and reduce the influence of external environment on the measurement results; The funnel and measuring cup have positioning devices to ensure that the center of the funnel and container are in a straight line.1989According to international standardsISO9136：Determination of Bulk Density of Coarse Grains and Industry StandardsJB／T7984.2-1999A specialized testing instrument developed and produced in accordance with the technical requirements of "Determination of Bulk Density of Coarse Grains in Ordinary Abrasives", while meeting the requirements ofGB/T20316.1-2009

Requirements for bulk density measuring instrument; Suitable for detecting the bulk density of coarse-grained ordinary abrasives used in the manufacturing of bonded and coated abrasives, as well as for detecting other granular materialsBulk densityThe detection method and results are completely universal with internationally recognized detection methods.FT-106

Ordinary abrasive

Bulk density testerworking principleLoad the abrasive to be tested into the funnel, open the discharge valve, and the abrasive naturally falls down along the lower end of the funnel and flows into the measuring cylinder. Scrape the abrasive that falls into the measuring cylinder flat, weigh the mass of abrasive in the measuring cylinder after scraping on a balance, and divide it by the volume of the measuring cylinder to measure the bulk density of the abrasive to be tested.FT-106

Ordinary abrasive

1.1Bulk density tester

1.2technical parameterMain technical parametersFunnel material: stainless steel;Funnel size: height240mm; Top diameter160mm; Export diameter:(20

±760.5)mm1；Distance between the bottom of the funnel and the upper opening of the measuring cylinder: （±）mm Measuring cylinder size: inner diameter64mm；Net height62mmMeasuring cylinder volume:.(200±
　　2.10.5) cm3Measurement error: ≤ ±0.02g/cm3Measurement error:≤±0.02g
　　2.2／cm3.
　　2.3Measuring cylinder volume:200±0.5cm3.External dimensions:230mm(Long)×250mm

(Width)×425mm(High)

FT-106Ordinary abrasiveBulk density testerPowder/Particle analysis instrument; Powder/Particle detection laboratory; Powder/