Integrated Probar flowmeter

High intensity probes can generate precise pressure distribution and fixed fluid separation points. The low-pressure tapping holes located on both sides behind the probe and before the fluid separation point can generate stable differential pressure signals and effectively prevent blockages. The internal integrated structure can avoid signal leakage, improve the strength of the probe structure, and maintain long-term high accuracy.

Performance advantages:

Can measure multiple media and has a wide range of applications

High precision and large range ratio

● Stable measurement signal with minimal fluctuations

Low permanent pressure loss of pipeline

The pressure tapping hole is inherently anti blocking

Low installation cost, basically maintenance free

● Can be installed and tested online

Measurement accuracy: ± 1% Repeatability accuracy: ± 0.1% Pressure range: 0~40Mpa, depending on the sealing pressure level.

Operating temperature: -180 ℃~450 ℃

Measurement upper limit: depends on probe strength, measurement lower limit: depends on the minimum differential pressure required for measurement range ratio: ≥ 15:1

Pipe diameter (mm): Φ 50~Φ 12000 (round pipe), side length 200~9000 (square pipe)

Applicable media: Full tube, unidirectional flow, single-phase gas, steam, and liquid with viscosity not exceeding 10CP

Calibration method: water or gas standard