HFC300-3Hydrogen fluoride moisture content online conductivity cellAccording to the requirements for determining the moisture content of hydrogen fluoride in the national standard GB7746-2011 (industrial anhydrous hydrogen fluoride), 304 stainless steel pipes are usedliningMade of polytetrafluoroethylene, used for measuring the water content of anhydrous hydrogen fluoride by conductivity method.

HFC300-3The conductivity cell is pre installed with high-purity platinum (Pt) electrodes, and the exposed part is a copper rod. It is connected to the conductivity meter through a PTFE shielded wire for use. Connect the DN25 standard flanges at both ends to the material pipeline or waste liquid recovery container.

HFC300-3It is the third generation hydrogen fluoride conductivity measurement cell, which fully absorbs the opinions and suggestions raised by users of the previous two generations of conductivity cells during use, and has achieved sufficient optimization in terms of leakage prevention and maintenance convenience.

Compared with the simple conductivity cell in the national standard, this conductivity cell is easy to install, has good sealing, corrosion resistance, and high pressure resistance (not less than 10kg). Its simple structure is also easy to clean and maintain, making it very suitable for online use and can also be used for offline laboratory measurements.

Main technical parameters：