Packaging specifications

1000-1200*1000-1200*500-1800mm

Turntable diameter

2000mm

Conveying height

500mm

Roller diameter

76mm

idler spacing

127mm

air pressure

0.4-0.7MP

Applicable film

width500mm, thickness18～25 μ, outer diameter220mm, inner diameter76mm, weight15KG/Roll, stretch ratio:200%

Packaging efficiency

10-25piece/hour

rotary speed

0-15change/minute

supply voltage

380V/50HZ

Whole machine power

2.82KW

Turntable weight

≤1500KG

Standard color

Main color:7035Computer white/Gray hammer pattern; Warning color: Lemon yellow (color can also be customized non-standard, additional fees will be charged)

Performance

1. PLCProgrammable control, winding layers and times can be changed

2. The photoelectric switch automatically senses the height of the goods

3. Automatic control of the upper and lower film coating processes.

Rotary table drive

1Rotary table chain drive, slow start, slow stop, automatic reset;

2.Turntable speed0～15 rpmFrequency Control

Membrane rack system

1. Open door membrane frame, more convenient for membrane penetration;

2. Membrane frame power frequency conversion pre stretching mechanism, pre stretching can reach200%；

3. The walking device is enclosed and self-lubricating; The rising and falling speeds of the film rack are variable frequency regulated, and the film feeding speed is infinitely adjustable;

4. The number of wraps at the top and bottom can be adjusted separately;

5. Thin film follow-up system, active film feeding.

Work steps

1Equipment0Place the wrapping film on the film holder, and after threading the film according to the schematic diagram, clamp the film head onto the clamp on the turntable.

2The product enters the equipment conveyor drum and is started. The product is connected to the winding machine, and the conveyor drum stops. Its position is controlled by photoelectric. Winding machine and front/There is relevant communication at the rear workstation.

3The turntable of the winding machine rotates, and the winding film is evenly wrapped onto the product. At the appropriate time during this process, the film clamp releases the film head, the blown film solenoid valve conducts the blown film, and the film head is wrapped around the surface of the product.

4When the winding is about to end, the turntable slows down and slowly stops at the turntable0At this point, the membrane frame is also at the lowest position. The film breaking mechanism operates to guide the film into the middle of the clamp, and the clamp is activated to clamp the film. Immediately after, the film broke and was scalded/Gently massage the membrane.

5After the ironing and cutting are completed, the film transfer mechanism returns to its original position. At this point, the conveyor line starts and stops after the product is output from the winding station. At this point, all functional components of the entire device are0Located and in standby mode.

6When a new product arrives, repeat the above process to achieve unmanned automatic winding of the entire machine.