MYW-A oil mist lubrication system-Fornitore globale

Mirang Technology, 5th Floor, Building A, Redwood Town, Gongming Street, Guangming District, Shenzhen, Guangdong Province

Performance and Features
·The system is equipped with solenoid valves that can be installed with pneumatic pressure regulating valves to precisely control the gas source and mix it thoroughly with the lubricating fluidReduce the wear and tear of mechanical cutting tools, and achieve better cooling and lubrication effectsIt mainly consists of an electric lubricating oil pump, an oil air adjustable mixer, a gas source two-piece, and pneumatic components, as well as solenoid valves and oilThe pump oil supply time is synchronized, the oil pump can adjust the mixer, and the oil and gas volume at each lubrication point can be adjusted in small amounts
·A. Digital display control: Both cooling and lubrication time and interval time can be adjusted. There is usually a lock key function inside, which can lock the settingsThe lubrication and intermittent system can be set later, and the "L U B" lubrication also has a power-off memory function, such as during operationThe interval is set to work for 16 seconds until the power is turned off at 14 seconds. The next time you power on, you can continue to count from 1 to 9 9 seconds,Interval of "I N T": 1-9 9 9 (seconds) Special requirements can be customized
·B. PLC control: Cooling and lubrication time and interval time are controlled by external PLC
·C. Uncontrolled: There is no need to control the cooling lubrication and intermittent time
·Equipped with a liquid level switch, the buzzer will emit an alarm signal and output an abnormal signal when the cooling lubricant is insufficient.The digital controller displays E R O when the liquid level is insufficient.
·The panel indicator light can display lubrication and intermittent status
·The system recommends using a pressure of 0 4 - 0 . 6 M P a
·Default liquid and tracheal diameter 6 mm
·It is used together with (MP V type) self-priming cooling lubrication spray.

Performance and Characteristics
· the system is equipped with a solenoid valve that can be equipped with a pneumatic pressure regulating valve to precisely control the air source and fully atomize it with lubricating fluid to reduce the loss of mechanical tools and achieve better cooling and lubrication effect. It is mainly composed of electric lubricating oil pump, oil and gas adjustable mixer, air source two couplings
and pneumatic components, electromagnetic valve and oil supply time of oil pump are synchronous, oil pump adjustable mixer, oil amount and gas amount of each lubricating point are adjustable in trace.
·a. Digital display control: adjustable cooling and lubrication time and intermittent time. 'LUB' lubrication: also has a power failure memory function, such as the working time set 16 seconds to 14 seconds of work, the next power can continue to press 14 seconds start timing 1-999 (seconds), 'INT' intermittent: 1-999 (seconds) special requirements can be customized
· b.plc control: cooling and lubrication time and intermittent time are controlled by external PLC·c. No control: no control is required for cooling and lubrication and intermittent time
· with liquid level switch, the buzzer will send out alarm signal and output abnormal signal when the cooling lubricant is insufficient. Digital display controller liquid level is insufficient to show ERO.
· the indicator light on the panel can show lubrication and intermittent state· air pressure of 0.4-0.6mpa is recommended for the system
· default diameter of liquid and trachea is 6mm· suitable for use with (MPV) self-priming cooling and lubricating sprayer.