Kit Filling and Sealing Machine

Product features and uses:

The reagent kit filling and sealing machine adopts a pneumatic gap operation mode, and the electrical appliance adopts a programmable logic controller. It has functions such as automatic cup dropping, filling, color code positioning, single pass heat sealing, tooth shaped cutting knife, automatic core cutting edge, and waste film recycling. This machine adopts an intelligent digital display temperature control system to control the sealing temperature, with a temperature error of less than ± 1%. High sealing strength and good sealing performance. The whole machine adopts a German programmable logic control system, and the body is designed with stainless steel, which complies with relevant food hygiene standards. The execution components of the equipment adopt a pneumatic control system, simplifying the mechanical structure and achieving excellent sealing quality, greatly improving the production efficiency and service life of the equipment.
This machine is suitable for various imported and domestic aluminum-plastic, PP, PZ, CPP and other roll packaging sealing materials. It is widely used in the packaging and sealing of plastic boxes (cups) in industries such as beverages, instant noodles, dairy products, soy products, fruit freeze brewing, etc. The finished products have the characteristics of uniform sealing, neat cutting, and good sealing.

Packaging samples:

Technical parameters:
Rotary speed: 13-16 pieces/minute
Production capacity: 800 to 100 cups per hour (customizable according to cup size)
Capacity: 50ml~300ml (customizable)
Heating power: 1 Kw
Gas consumption: 0.3 cubic meters per minute
Power supply:~ 380V 50Hz
Dimensions: 1300mm × 1300mm × 1750mm
Key point: Approximately 200kg

Product and Detail Display:

Product maintenance and upkeep:

1. Before starting up, check if the pressure of the gas source is normal, and generally maintain the pressure between 0.6-0.7Mpa. The wastewater in the air filter should be discharged regularly to ensure the normal operation of the cylinder. The connection between the clutch (pawl) and the driving cylinder should be regularly oiled to avoid damaging the parts and affecting the production quality and service life.
2. After the work is completed, let the heat sealed part cool naturally and clean the inside of the filling cylinder with hot water. Drain the water through the drain port or press the "filling solenoid valve" to release the water* Afterwards, clean the dirt on the aluminum plate to prevent premature corrosion and aging.
3. Regularly check for dirt on the sealing ring to ensure sealing quality.
4. Check if the grounding wire of the machine is in good contact to ensure safe use of electricity.
5. Before working, adjust the sealing temperature from low to high to ensure more uniform heat sealing temperature and better sealing effect.
6. If a fault is found, the emergency stop switch should be pressed immediately, and all the actuators of the equipment will be reset immediately. Then turn off the power, check the cause, eliminate the fault, and restart.
Technicians carefully organize product parts: