Suitable for large injection molding machines with 800-4000 tons, it is a 3-axis AC servo drive, single arm cow head type, and a double section upper and lower arm structure; The up and down travel is 1500/1700/1900/2200/2500/3000mm, the horizontal travel is 2600/3400/3700/4200mm, the front and rear travel is 1400/1800/2250mm, the removal time is 7-9 seconds, the full cycle time is 21-26 seconds, the standard load is 30 kilograms, and the heavy load is 50 kilograms (including finished products and fixtures). Used for quick or diverse removal applications, especially for long shaped heavy-duty products such as car bumpers, door trims, large home appliance casings, etc.

characteristic:

Standard Features

Packing action (256 points on each axis)

Free packing point (115 points x 2 locations)

Remove the lateral forward posture control

Walking posture during the journey

Posture during descent testing

Top pin linkage

Defective product discharge circuit

Initial defective product discharge circuit

Take out the descent standby mode

Adhesive opening on the way (outbound, return)

Open inside the water outlet mold

Suction confirmation unit (1 circuit)

Horizontal standby mode

Slip out circuit

Conveyor belt start signal

Internal storage memory (* 100 types available)

Set value locking function

Fixed and movable switching

Switching between two languages (Chinese, English)

Option function

◆ Scissor circuit inside the fixture

◆ NT cutting · movable side

◆ Suction confirmation 2 circuits

◆ Product clamping with 2 circuits

◆ Suction confirmation 4 circuits

◆ Product clamping with 4 circuits

◆ Closed mold during ascent

◆ Rotary unit

◆ Top pin reverse linkage

◆ European standard 12/67 interface

Specification parameters:

Customer case site: