**Input voltage, current, thermistor, thermocouple without jumper * * Input, simple and flexible

Electromagnetic compatibility EMC III level, super strong anti-interference ability, suitable for various complex sites

Design of High Efficiency and Wide Voltage Switching Power Supply for Wide Width Power Supply

Shelf life of 5 years with an average time between failures (MTBF) greater than 1.2 million hours

Strong adaptability, wide range of temperature and humidity adaptation, and small drift

Note: Level III - Suitable for typical industrial environments. The applicable places for industrial engineering equipment, such as power plants and outdoor high-voltage substation relay rooms, can serve as representatives of such environments.

Level II - Suitable for use in protected environments. The control room or terminal room of engineering and power plants can serve as a representative of such environments.

I - Suitable for environments with good protection. The computer room can serve as a representative of such environments.

*AC85V~265V (efficiency up to 920%, DC10V~36V.

*The hardware failure repair rate of the entire machine is less than 0.5%, and the warranty details are in accordance with the manufacturer's regulations.

give birth to

technical specifications

4 Power supply: 85V AC~265V AC, 120VDC~380VDC, power consumption less than 6W

12VDC~36VDC， Power consumption less than 6W

★ Note: The DC power supply should have a certain power margin. Please configure the power supply according to 24VDC/0 * * and 12VDC/2A per unit. Pay attention to the length and diameter of the power cord.

4 Working environment: 0 ℃~50 ℃, humidity below 90% R.H, no condensation.

4 Display range: -1999~9999, decimal point position can be set

4 Input signal types: * * Input, can be selected through parameter settings

Note: When placing an order for 0~10VDC input, please indicate or modify it by the user. Remove the instrument panel casing and connect the instrument motherboard (the circuit board where the input signal terminals are located)

Cut off the connection between SL1 on the back of the circuit board (the back of the component) where the input signal terminal is located, and then modify the input signal selection parameters. At this time, the instrument can only input voltage and current signals.

4 Basic errors: less than 0.5% F.S

4 measurement control cycle: 0.2 seconds

4 Alarm output: 2-point relay output, contact capacity 220V AC, 3A

4 transmission outputs

- Optoelectronic isolation, output resolution of 1/3000, error less than ± 0.2% F.S

DC current or DC voltage output should be specified when ordering, with a load capacity greater than 600 Ω.

When outputting DC current, 4mA~20mA, 0mA~10mA, 0mA~20mA can be selected through setting; When outputting DC voltage, 1V~5V and 0V~5V can be selected through setting.

-0V~10V transmission output, please specify when ordering

★ The transmission output is an optional function and needs to be specified when ordering, otherwise the instrument does not have this function.

When the external 12V supply also has A1 or A2 type transmission output function, the transmission output load capacity is 450 Ω